Battery times

Common methods oflaptop battery repair

laptop battery ,especially li-ion battery idle for too long or just repaired, It’s charge curve and discharge curves are generated by a certain offset, The need for a real full release cycle completion of several steps to remedy the repair charge and discharge curves,we also called the battery’s self-learning process.Common laptop battery repair,there are mainly two.

Method 1:

1.Set up(This is the most related to the cell can repair to the best of the most important step,please note that we do not need friends)

.Open my computer,Control Panel Power Options Power Schemes, To use the battery all the time parameters chosen never ,and will alert the two options untick items,purpose is when the battery down to a few percent of the time for the operation does not respond accordingly, Laptop battery for the real release complete,amended so that the battery itself,the minimum charge and sync curve 0%.

2. Discharge

After the above settings finished,put on full completion by , principle to the battery charge and discharge,two or three times back and forth,you can repair the battery over the curve offset.

Note:

Must allow the battery charge when full,the best way is to charge off a few hours or overmight,then unpiug the power supply discharge,off until the computer automatically shut down athis back and forth at least two cycles.

Method2:

charging the battery in use and will cause instability in the capacity of the battery doen, but this decline is not due to aging caused by, Therefore, proper calibration can make this part of the recovery of lost capacity.

therefore,regular battery calibration is very necessary thing .
Such as 1-2 months time. Such as Compaq and IBM laptop’s own power management in BIOS or a program to provide a battery calibration, so use two brands of friends,according to instructions that you can. For those who da not provide this feature the brand’s users can follow my steps below:

• 1.The screen saver is set to ;none
• 2.In the Windows Power Management power scheme will be set to “always open” and shut down equipment related to the following menu all set to “Never.”
• 3.In the alert tab will be ;insuffcient power warning;is set to 10%,the operation is set to ;da nothing;:will be; a serious power shortage alert,;set to 3%,operating as a ;stand-by;.
• 4.Screen brightness set to maximum.
• 5.Confirmed that all the windows closed, and save all the data before the work.
• 6.Sure the batteries are charging more than 80% after the power and unplug all external devices, then if the screen automativally reduces brightness,then turn it hit yhe bridhtest.

OK ,you can go to sleep ,after the discharge end of the notebook will shut off the power plug for laptop charging,attention must wait after completely full of boot,and then restore power to xiaozhun before the program settings,calibrated the battery ,you can rest assured that use.